CG76B protection corners

Corner bump vinyl, on a budget to protect the corners from bumps. This bumper will fit in any room where there are no gurneys. The perfect solution to protect the corners in reception areas, offices, classrooms and any passing zones. As well as due to its antibacterial characteristics, these bumpers are suitable for medical centers and is a popular choice protect the corners from wear and tear of interior trim.

Accessories:

• Vinyl profile 2 mm

Installation:

1. Define the height of the corner bump.
2. If you need trimming of the bumper, use a mounting a saw or a construction knife and a metal ruler (a square).
3. Make sure the wall is dry and clean.
4. Remove all the irregularities of a wall for best results.
5. Before applying the adhesive, wipe both sides of the bump, to make sure that the surface is free of dust and dirt.
6. Apply glue only to the surface of the walls to distribute adhesive to use a spatula D2 or B3. It is recommended to use contact adhesive water-based (KIILTO EXTRA, DENLAKS TK-580). Consumption 300-350 g of adhesive per 1 m2.
7. Allow the glue to harden in normal conditions it takes approximately 10 to 15 minutes. However, the duration of curing depends on temperature and humidity.
   Important: Read the specification of glue or other adhesives before applying.
8. Place a sheet of bump on the wall, level and press it in place manually.
9. Roll a strip of fence using pressure roller. Start rolling in the center of the sheet and move to the edges. After the installation, remove excess adhesive.

Note: This model has no equipment no accessories.

• Каталог - Системы защиты стен и углов АРФЕН 2018
• Цветовая палитра - Отбойники
• CG25B, CG50B, CG76B - Монтаж