Slab Joint is a reinforced shrink joint for concrete floors of warehouses, parking lots and logistics complexes.

The profile of the non-removable formwork is designed for installation along the boundary of the gripping of the concrete floor filling. It is installed and fixed in the concrete preparation immediately before pouring the floor. A special steel edge protects the edge of the plate from chipping under loads and during deformation movements. Also, the installation of the formwork allows you to significantly reduce and compensate for shrinkage movements and cracks. Special anti-shrink plates prevent vertical drawdown of cards relative to each other.
 

Using:

• warehouses
• logistics complexes
• parking lots
• factories, factories
• hangars
• shopping centers
• any industrial concrete floors on which the movement of warehouse loading equipment is provided
   

1. Upper flat steel "Lip"
2. The lower steel plate (directly the formwork) is from 115 mm to 300 mm high
3. Anchors poured into concrete D = 10 mm, length 100 mm, pitch 250 mm
4. The plate for filling is 8 mm thick, and the pad on it is made of ABS plastic
5. Foot for mounting to the base (optional)
6. Plate for height calibration (optional)
7. Plastic bolt for breaking (polyamide)